Dryer vent cleaning
Whole-home duct cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Fast, Reliable Dryer Vent Cleaning Across Inwood
Dryer vent cleaning in Inwood, NY usually runs $150 to $350 for a single apartment unit, and a shared stack serving multiple units typically lands between $400 and $900 depending on how many apartments and how long the interior run is. Those are estimates only; the written estimate you get after an inspection sets the final price. If your dryer is taking two or three cycles to dry a load, or your co-op board is asking about lint buildup in a shared riser, call (855) 658-4077. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
We know Inwood’s buildings, and that matters more here than in most neighborhoods. The six-story brick walkups along Broadway and Seaman Avenue and the high-rises at Park Terrace Gardens and Inwood Houses don’t have dryer vents that pop straight out a wall. They run through shared risers. Getting one cleaned properly takes more than a shop vac and a brush.
Why Inwood Homeowners Call Air Duct Cleaning Kingsbridge for Dryer Vent Cleaning
We bring professional-grade equipment, not off-the-shelf tools. A Rotobrush or Nikro system under negative pressure pulls lint out of a long interior run instead of just pushing it around behind the machine. That’s the difference between a cleaning that actually clears the fire load and one that only looks done from the outside.
Inwood residents and managing agents call us because we understand how these buildings are put together. When a single apartment’s vent ties into a shared shaft, we explain what the problem is before we start and show you what we find with a camera inspection. Co-op boards get a written scope they can approve. Tenants get a straight answer. Property managers get documentation of the run, the cap, and the exterior termination.
Response time to Inwood is fast, and we’re set up to work in buildings where the elevator is the only way to move equipment to an upper floor. Our technicians have up to 9 years of experience with this equipment, and we’ll tell you before we arrive what the estimate covers and what it doesn’t.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Our Dryer Vent Cleaning Services in Inwood
Dryer Vent Inspection
An inspection comes first, every time. In an Inwood apartment, that means camera inspection of the run from the machine back to the exterior cap, with attention to where a vertical riser joins the stack. We look for crushed or disconnected joints you can’t see from the laundry area, and we check whether the exterior termination on a high-rise facade is open, crushed, or packed with lint.

Vent Cleaning (Source Removal)
Full source removal is the core of what our dryer vent cleaning team does. Agitation tools under negative pressure loosen and pull lint along the entire pathway, including the flex run behind the appliance and the interior riser. That matters in a dense building where the actual fire load sits deep inside a wall, not in the short stub behind the dryer.
In pre-war Inwood walkups, many dryer exhausts don’t run straight outdoors. They tie into shared vertical shafts alongside bathroom and kitchen exhaust. One apartment’s lint complaint often implicates the whole stack, and resolving it fully takes coordination with a co-op board or managing agent to open access to every affected unit. We work with that process instead of cleaning one apartment and leaving the buildup in place above and below it.

Lint Removal
Lint removal covers the parts of the run the shop vac can’t reach: the length of the riser, the elbows, and the duct-to-cap transition. In the older metal ducts common in Inwood, condensation cycling between humid summers and cold, windy winters softens lint into clumps that cling and compress. Agitation breaks it loose and the negative pressure carries it out.

Vent Rerouting
Sometimes the run itself is the problem. A corrugated foil flex hose behind an older machine feeding a shared riser is common, and it’s often crushed at a corner or sagging where it collects lint. Rerouting shortens and straightens the pathway where the building allows it. That’s a scope decision for the co-op board or managing agent, and we’ll tell you honestly when a reroute is worth the cost and when cleaning is enough.
Trusted Brands We Service in Inwood
Dryer vent work and air quality work go hand in hand, and we carry equipment from Nikro and Abatement Technologies for the job, along with Guardsman-brand treatment products. Where a building’s filtration or humidity control comes up as a follow-on question, we work with Honeywell and Aprilaire systems. We don’t stock parts locally. If a replacement cap or bird guard is needed, we’ll tell you what fits and get it arranged. One call covers the vent cleaning, the inspection, and anything else the run turns up.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Inwood Homes
- Cleaning only the stub behind the dryer. The short flex hose from machine to wall is the easy part. In a six-story Inwood walkup, the long interior riser run is what actually feeds a fire, and skipping it leaves the real fire load untouched.
- Skipping board coordination. When access above or below the source is never granted, the shared-stack buildup comes right back. The managing agent or co-op board needs to authorize access to all affected units for the cleaning to hold.
- Replacing a cap without checking the termination. On a high-rise facade, a crushed or bird-nested cap chokes airflow on the whole run. A new cap that’s fitted without confirming the run behind it is clear solves nothing.
- Cold-weather condensation buildup. Inwood winters push the heat hard, and the warm humid air leaving a dryer through a cold exterior wall condenses inside older metal ductwork. That turns lint into a dense, sticky coating that a light pass won’t remove.
Pricing for Dryer Vent Cleaning in Inwood, NY
A typical single-apartment dryer vent cleaning in Inwood runs $150 to $350. A shared vertical stack that needs access to multiple units is usually $400 to $900, priced per run and per unit, never per foot. Dryer vent inspection alone is estimated at $75 to $150. Vent rerouting where the layout allows it starts around $300 and goes up with run length and building access. Bird guard and cap replacement is estimated at $100 to $250, depending on how the termination on a high-rise facade has to be reached.
One flat price per system, agreed before work starts. No per-vent pricing, and no teaser figure that grows once we’re on site. What drives the range is run length, how many units share the stack, whether the co-op board or managing agent has to be involved, and how the exterior termination is accessed. The estimate is free. Call (855) 658-4077 to get an exact figure.
We Also Serve Cities Near Inwood
The same equipment and process go with us into University Heights, Kingsbridge, Spuyten Duyvil, and Washington Heights, and we work throughout Inwood itself. If you’re a property manager with buildings on both sides of the Harlem River, one call covers all of them. The shared-stack problem doesn’t stop at the neighborhood line, and neither does the work.
Serving Inwood, NY – Our Local Coverage Area
We serve Inwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Inwood
Your co-op board or managing agent authorizes access to units beyond your own, and sometimes the building’s property manager does. We need written approval for each unit we open. We’ll provide the inspection findings and the scope so the board can decide, and then we coordinate access unit by unit. We don’t clean around a stack problem; the buildup returns if the whole run isn’t cleared. Call (855) 658-4077 for an exact quote; estimates are free.
Because the lint pathway is restricted, and in these buildings it’s usually not the machine’s fault. A qualified pro typically finds a long interior vent run, often corrugated foil flex behind the machine feeding a shared riser, packed with lint and a crushed or disconnected joint that a shop-vac-and-brush job can’t reach. Using camera inspection and agitation tools under negative pressure, the tech performs source removal along the full lint pathway and documents the run for the board. Call (855) 658-4077 to schedule a free estimate.
Often yes, and it should be checked on every job. A high-rise facade termination can get crushed, bird-nested, or packed with lint. A new cap solves nothing if the run behind it is still blocked. We check the termination as part of the inspection, and if a guard or cap replacement is needed we price it in the estimate before we start. Call (855) 658-4077 to book an inspection.
Call us first and tell us the building’s access rules, then we’ll set the appointment. Before we arrive, tell us about parking restrictions and whether equipment has to move by elevator. We’ll plan the visit around your building’s rules and carry the tools needed for an upper-floor job. Our technicians have up to 9 years of experience working in apartment buildings. Call (855) 658-4077. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
It means source removal along the whole pathway under negative pressure, not just a pass at the visible stub. In a shared Inwood stack, that includes camera inspection from machine to exterior cap, agitation of the full riser run, checks on the exterior termination, and documentation that lets a co-op board see exactly what was found and why the fix may extend beyond one unit. It also means coordinating access with the board so the work is done unit by unit, not guessed at. Call (855) 658-4077 for an exact quote; estimates are free.
If your dryer is slow, your lint trap is filling fast, or a board or managing agent is asking what’s going on inside the stack, we can tell you what we find before any work starts. We use professional-grade equipment under negative pressure, and we show you what we find with a camera inspection. Call (855) 658-4077 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Air Duct Cleaning Kingsbridge.